Tenaci Adjustable Hydraulic Clutch Release Bearing kit 240 mm (high) for Toyota and GM

3 895,00kr incl. TAX
3 116,00kr excl. TAX

This bearing fits Toyota R154 gearboxes and some GM gearboxes such as Midvalley 101.
See the bolt pattern in the images.

This is an adjustable bearing that is locked either with with a key that can be included. (t02811112)
Or it can be locked with a M8 bolt. The M8 bolt fits directly on some GM gearboxes but has to be drilled for R154.

Choose bearing length (+10 mm or standard, see product images)

Bleeder threads: 3/8-24

There are 4 different bearing sizes to choose from.

1. 184/200 mm this option fits all 184/200 mm clutches including Tenaci as well as other manufacturers.

2. 240 mm (high) 55,82 mm this bearing fits only the 240 mm Tenaci clutches.

3. 240 mm (low) 45,66 mmThis bearing fits only the 240 mm Tenaci clutches.

4. 215-240 mm for Sach and Tenaci “black”
This bearing can be used for clutches from other manufacturers with sizes from 215-240 mm.

Buy more options :

Tenaci hoses for hydraulic release bearing

Adjusting tool and locking nut for Tenaci Adjustable Hydraulic Clutch Release Bearings

SKU: tm00184207 Categories: , , , ,

Description

For 184, 200 or 240 mm clutches

Make sure that you use the correct clutch cylinder so the release bearing doesn’t get overfilled. This could lead to oil leaking on the rubber rings which would wear out the bearing. You could use 0,65″ but 0,75″ is recommended with pedal-stop. Or OEM-cylinder with pedalstop.

Also make sure that there is at least a 3 mm gap between the pressure plate and the bearing. When the discs wears out the gap is neccesery so that the clutch doesnt burn up.

Film about our bearings:

https://www.instagram.com/p/B-wyzNjFN4h/

https://www.youtube.com/watch?v=fwCHIPZksG8

A positive clutch pedal stop must be used to prevent over-stroking the
hydraulic release bearing piston and the clutch. For access reasons, in many cars
it is not easy to determine how far the master cylinder is being stroked.
The method listed below provides a very effective method for adjusting the
pedal stop:
1. Lift the drive wheels off the ground and support the car on jack stands.
2. With the engine off, place the gearbox in first gear and have someone
attempt to rotate the drive wheels.
3. Depress the clutch pedal slowly until the clutch disengages and the drive
wheels can be rotated.
4. Adjust pedal stop to allow another 1/4″ of pedal travel. This should provide
clean release of the clutch. Do not stroke the pedal any further than this
point throughout this procedure, otherwise you will over-stroke the clutch.
It is also recommended to install a bleeder outside of the bellhousing for bleeding out airbubbles.

Additional information

Weight 2 kg

Related products